Influence of Fixation Mode and Superstructure Span upon Strain Development of Implant Fixed Partial Dentures

Influence of Fixation Mode and Superstructure Span upon Strain Development of Implant Fixed Partial Dentures
January 2008
Matthias Karl,DMD, Manfred G. Wichmann,DMD, Werner Winter, Dr.-Ing, Friedrich Graef, Dr. rer. nat., Thomas D. Taylor, DDS,& Siegfried M. Heckmann, DMD

Abstract

Purpose: Implant-borne fixed partial dentures (FPDs) should fit passively in order to avoid complications ranging from screw loosening to loss of osseointegration. The aim of this study was to measure the strain development of three-unit and five-unit screw- and cement-retained implant-supported FPDs. Additionally, the influence of the parameters retention mechanism and FPD span were evaluated.

Materials and Methods: Three Straumann implants were anchored in a measurement model based on a real-life patient situation and strain gauges (SGs) were fixed mesially and distally adjacent to the implants and on the pontics of the superstructures. During cement setting and screw fixation of 40 implant FPDs (10 samples from each group: three-unit cementable; five-unit cementable; three-unit screw-retained; five-unit screw-retained), strain development was recorded. For statistical analysis, multivariate two-sample tests were performed with the level of significance set at p = 0.1.

Results: The mean strain values for the four FPD groups at the different SG sites ranged from 26.0 to 637.6 μm/m. When comparing the four groups, no significant differences in strain magnitude could be detected. Similarly, a comparison of the two FPD spans revealed no significant difference (p = 0.18 for cementable FPDs; p = 0.22 for screw-retained FPDs). A comparison of the two fixation modes also revealed no significant difference (p = 0.67 for three-unit FPDs; p = 0.25 for five-unit FPDs).

Conclusion: FPD span and retention mechanism appear to have only a minor influence on strain development in implant FPDs. As implant-supported restorations have proven to be successful over time, the question arises as to whether an "absolute" passive fit is a prerequisite for successful implant restorations.

NOTE: This article may be viewed in its entirety by subscription or by purchase at the website.